XS650 Direct

LED Charging system indicator Gauge. Shows Voltage of your alternator rising and
falling with RPM and gives a clear indication of your charging systems normal
operation and early warning of problems.
Gauge is Bright High Quality Chrome plated and clamps onto 7/8" Bars and can be
easily wired into any point in the system (before a switched load is best). Can be
mounted as shown or to handlebar by clamp (included).
Fits: All 650's 1970-84

Alternator Stator Assembly for factory Tci Ignition type models.
Fits: 1980-84 North American models.
Complete New assembly includes New Stator Housing, Stator assembly with wire
harness, Brush Holder, New Brushes and Brush holder Guard.

Only your original 80-84 TCi trigger needs to be installed.

Note: No core required or accepted. Ready to install & run!
USA made stator.

Alternator Housing Mount Screws - Special 6mm. (pk/2) Fits: All 650's.
Screws to mount alternator stator housing to engine.

New Alternator Rotor for 70-84 XS/TX650's (TCI Ignition or points models).
Not a rewind - No core required or accepted - These are New production!

Alternator Rotor Puller - Safely pulls rotor without damaging it. Fits: All 650's.

Alternator rotor nut and lockwasher set

Alternator Brush Set - Fits: 1980-84 XS650. Complete set as shown. Replace
brushes if carbon brush is 7mm. (0.276") or less.

Note: To install pull brush assembly around to opposite side of metal
bracket its soldered to and then insert into holder.

Alternator brush Holder & mount Screws - Fits: All 1979-84 650's. We recom-
mend this be replaced if yours is cracked, broken or oil or grease inpregnated.

Brush holder Guard with mount Screws(2) - Fits: All 650's 1970-84

Solid State Rectifier/Regulator for 1980-84 XS650. Made in Japan by original
supplier. Direct plug in replacement for 1980-84. Not for use on earlier models.

Gasket - LH Crankcase Cover. - Fits: 1972-84 650's.
OEM Ref.# 306-15461-00

Polished Billet Aluminum Alternator Cover (No Yamaha name). Fits: 70-84 650's.

Polished Billet Aluminum Alternator Cover with XS Performance
Logo CNC cut into cover face/
Fits: 70-84 650's

Coupler Set with Terminals - 6 space (Large Flat Spade type). This coupler set
connects the 1970-84 650 alternator to the stock wiring harness.

Coupler Set with Terminals - 8 space (Large Flat Spade type). This coupler set
connects the 1980-84 650 Rectifier/Regulator to the stock wiring harness.

Coupler Set with Terminals - 3 space - Large Flat Spade type. Set for stock
factory TCI Ignition trigger wire to stock wire harness (with terminals).

Neutral switch rubber Cap - Fits: All 650's (neutral wire runs from alternator loom).